Measurement guides
Start with the full assembly
A door leaf measurement is not the same as the overall frame opening. Where fixed glass, two leaves or several sliding panels are involved, show the full assembly on a sketch. Label the dimensions you know and identify whether they were taken from the building opening or the existing frame.
Describe the access you need
The unobstructed passage depends on the operating arrangement and hardware, not only the overall width. Explain whether people, furniture or equipment must pass through. Where a professional has issued a specific access requirement, include it in the brief rather than assuming that a nominal door size meets it.
Show floor and threshold information
Measure or photograph the relationship between the internal floor and outside surface where safe to do so. Mark unfinished flooring or planned level changes. The lower junction is part of the complete installation discussion and should be considered before final height and fitting details are approved.
Record swing and panel positions
For hinged doors, show the preferred hinge side and opening direction. For sliding or stacking doors, indicate the desired moving panels and parking position. A total width and height without this information can describe several different products, each providing a different form of access.
Use estimates for the enquiry only
Give widths and heights in millimetres, with quantities and opening references. Avoid applying a standard deduction or treating visible glass dimensions as frame dimensions. The team will clarify the chosen system and responsibility for confirming final measurements before the manufacturing schedule is approved.








